Ford Performance GT350 5.2L Voodoo Intake Manifold (15-23 Mustang GT, GT350)Find parts that fit my vehicle

Increase Top End Power. Are you a competitive racer on a quest to increase the top end power of your Coyote powered GT Mustang? Then look no further than a genuine Ford Racing GT350 5.2L Intake Manifold. The Shelby GT350 Intake Manifold is tuned for 7500 RPM peak power increases with little or no loss in low end torque. Designed to improve airflow which in turn produces bigger performance gains at higher RPMs, makes this GT350 Intake ideal for the racer looking for that extra boost of top end power.

Ford Racing Quality. When you're adding performance parts to your Pony, trust the folks who know it best to untap hidden potential and unleash the monster under your hood. Ford Racing proudly designs and manufactures their GT350 Intake Manifold right here in the USA. Manufactured from a high tech, lightweight composite material, this Intake Manifold is assembled with the charge motion control valves already in place.

Calibration Required. To realize the full potential of this Intake Manifold, AmericanMuscle recommends a custom tune with a Mustang Handheld Tuner. By reprogramming the vehicles computer (ECU) to you will be able to take full advantage of the higher RPM capabilities this Shelby GT350 Intake Manifold has to offer.

Required Throttle Body Upgrade. Installation of this Ford Racing Shelby GT350 Intake Manifold will require the use of a GT350 87MM Throttle Body, M-9926-M50B, for operation.

Application. This Ford Racing GT350 5.2L Voodoo Intake Manifold is a direct fit service replacement for the GT350 and GT350R Mustangs. This GT350 Intake Manifold can also be installed on 2015 to 2023 GT Mustangs equipped with the 5.0L 4-Valve DOHC V8 engine.

Technical Note. To install the GT350 Intake Manifold on a 5.0L Mustang properly, you will need to modify some vacuum lines, plus extend the EVAP solenoid wiring harness. Additional hardware that is needed to make these modifications are not included.

Please Note. This part has been designed and is intended for off-highway application only. Installation of this part on a vehicle that is driven on public roads may violate U.S. and Canadian laws and regulations relating to emission requirements and motor vehicle safety standards.

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov