How To Install Third Brake Light Trim - Black on Your 2010-2014 Mustang V6 or GT

Hardware included in the box:

(1) Quarter Light Trim
(1) Alcohol pad

Installation procedure:

1. Safety first! Make sure engine is turned off and vehicle is parked on a level surface.

2. Locate Third Brake light on rear trunk lid. Prep area using alcohol pads. Wipe area around light to remove all debris for proper fit.

3. Peel 3M tape backing.

4. Place black trim directly on third brake light, press firmly to allow product to adhere.

5. Do not drive vehicle for the first 10 minutes to allow proper bond. Do not wash car for 24 hours to prevent adhesive from peeling off. This is what product should look like after proper install

Installation Instructions written by AmericanMuscle Customer Allen Syed 10.30.2014