How to Install Centerforce Dual Friction Clutch Disc on your Mustang

Flywheels: All Centerforce® clutches need to be installed on a clean, properly resurfaced or brand new fl ywheel. Flywheels must be within original equipment specifi cations. Centerforce clutches are designed to be used on fl ywheels made of cast iron, steel, or aluminum with steel inserts. Break-In: All Centerforce clutches require a break-in period of 450-500 miles of stop-and-go street driving before applying full engine power. This period is required to properly seat the disc with the pressure plate and fl ywheel. Balance: All Centerforce clutches are balanced from the factory to meet or exceed Original Equipment (O.E.) specifi cations. Balancing with the Centerforce weights installed on the clutch assembly may cause an outof-balance condition. Removing the weights without permission from Centerforce may void the warranty. Centrifugal Weight System: If your new Centerforce clutch is equipped with the patented centrifugal weight system, do not remove the ring, weights, or spring wire retaining the weight system to the diaphragm fi ngers. If your Centerforce clutch does not include the centrifugal weight system, it is because there is not suffi cient clearance for Centerforce to safely & effectively install the centrifugal weight system. Failure to follow the above procedures will void your warranty and may result in decreased performance and/or premature wear! Questions? Please contact the Tech Department at Centerforce