How to Install a Eibach Pro-Kit Springs - Coupe & Convertible on your 2003-2004 Mustang Cobra

PRO·KIT - # 3594.140

2003-2004 Ford Mustang Cobra Coupe/Convertible (w/IRS)

NOTES: Read All Instructions Before Beginning Installation

• Installation of a PRO-KIT Spring set should only be performed by a qualified mechanic experienced in the installation and removal of suspension springs.
• Use of a hoist is highly recommended and will substantially reduce installation time.
• Never work on or under a vehicle unless it is properly supported by safety stands and wheels are blocked.
• PRO-KIT Springs are marked with 001 and 002 (located at the end of the part number) designating front and rear spring respectively.
• PRO-KIT Springs should be installed with the Eibach Logo right side up. All original stock spring isolators, dampers and tubing should be retained from the stock springs and reused
• After installation, it is always important to inspect and adjust the following if necessary:
  • Wheel alignment such as camber, caster & toe
  • Tire and/or wheel fender clearance
  • Brake line clearance and attachments
  • Brake anti-locking and anti-skid system sensors
• Tire Rotation: To increase the life of your tires, it is recommended to rotate your tires every 3,000 miles.

Alignment:

• After installation, it will be necessary to perform a full vehicle alignment using factory specifications.

Additional Eibach Components Available For Your Car

Bump Stop Trimming Instructions No bumpstop trim needed.