Mustang Hood Scoop Billet Grille Insert ('99-'04 GT) - Installation Instructions

1. Start by cleaning the factory plastic honeycomb insert with soap and water. Then check to be sure this is securely attached.

2. You will need the honeycomb insert to remain in its factory location, inside your hood scoop, to attach the Billet Grille insert.

3. Once you are sure the factory honeycomb is firmly attached in the factory location, take your Billet Grille overlay which should have come with four (4) stay ties. At each of the four post corners (where the vertical and horizontal bars meet) wrap the stay ties around your factory honeycomb and your overlay.

4. Do your best to keep the squared piece on the stay tie out of sight so as you tighten it, you end up with an invisible and extremely secure fit.

5. Last, you’ll need to snip the long ends off the stay ties for a completely invisible look.

6. Give a quick pull on the overlay to be sure you have tightened it down flush with the honeycomb and that you hear do not rattling before you are finished.