JLT Cold Air Intake with Red Oiled Filter (15-20 Mustang GT350)Find parts that fit my vehicle

Increase Horsepower. Add even more horsepower and torque to your 526 HP Shelby GT350 with a custom tune and this JLT Performance Cold Air Intake. This textured black cold air intake completely replaces your factory air filter and housing assembly with a red high flow filter assembly to maximize your air flow. Not only will this CAI improve your Shelby's overall performance, JLT designed the intake tube to be 4.5 inches at the throttle body side in preparation if or when you decide to install a larger aftermarket throttle body.

120mm MAF Housing. This GT350 Cold Air Intake features a unique design that was fully computer designed to provide the best fit and finish possible. It incorporates a massive 120mm MAF housing into the textured black plastic tube, that gives it a clean factory appearance (MAF Sensor is not included).

Heat Shield Included. JLT includes a roto molded ABS plastic heat shield with a fresh air duct that goes to the grille. The heat shield is designed to block out excessive under hood engine heat at low speed and idle, that can rob you of power. The fresh air duct keeps the inlet temperatures as cool as possible when the air flows into your filter. 

Money Saving Reusable Filter. The JLT Performance CAI comes complete with a massive 5x8 in. high flow reusable S&B brand air filter. That means there is no need to go out and purchase a new filter every few thousand miles. You can just clean the filter, re-oil it, save money and get back on the road!

Simple Installation. JLT designed this Cold Air Intake to be installed easily with the use of basic hand tools. No extra modifications or special tools are required for installation. All of the necessary parts and instructions are included.

Required Upgrade. Installation of this Cold Air Intake will require the use of a custom tune with a Mustang Handheld Tuner. It would reprogram the vehicles computer (ECU) to get the best performance possible out of the intake.

Application. This JLT Cold Air Intake is specifically designed for use on the 2015 to 2020 Shelby GT350 and GT350R models equipped with the Voodoo 5.2L V8 engine.

Technical Note. This JLT Cold Air Intake is not legal for use in California or other states adopting California emission standards.

Fitment:

• 2015 Ford Mustang
• 2016 Ford Mustang
• 2017 Ford Mustang
• 2018 Ford Mustang
• 2019 Ford Mustang
• 2020 Ford Mustang

Details

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov