J&M Rear Lower Control Arm Relocation Brackets; Black (93-02 Camaro)Find parts that fit my vehicle

&M Products relocation brackets will allow you to change your instant center by lowering the rear control arm angle. Lowering your axle side rear control arm will increase traction, reduce wheel hop, and give you better anti-squat. These high strength brackets are made from 3/16″ cnc laser cut and cnc formed cold rolled steel. J&M’s LCA brackets will lower the rear of the control arm up to 3″ and work with all control arms. These are a must for lowered vehicles to recover lost control arm angles. Our bolts in brackets are available in red or black powder coat for a very long lasting great looking finish. Weld-in brackets are available in bare steel only. All instructions and hardware are included.

Lower Control Arm Bracket Features and Benefits:
3/16″ CNC laser cut cold rolled steel
CNC formed out of 1 piece of steel (not 3 pieces welded together) for the ultimate in strength and durability
Bolt-In brackets come standard in red or black powder coating for a great looking long lasting finish
A necessity for any performance minded builder
Improves a launch which reduces 60 foot and 1/4 mile times.
100% MADE IN THE USA

Fitment:

• 1993 Chevrolet Camaro
• 1994 Chevrolet Camaro
• 1995 Chevrolet Camaro
• 1996 Chevrolet Camaro
• 1997 Chevrolet Camaro
• 1998 Chevrolet Camaro
• 1999 Chevrolet Camaro
• 2000 Chevrolet Camaro
• 2001 Chevrolet Camaro
• 2002 Chevrolet Camaro

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov