Guaranteed 12/24 Delivery Still Available see item page for details! available on most items - Details
Best Sellers
How to Install MMD Headlight Splitters on your 2013-2014 Mustang GT and V6
Shop Parts in this Guide
Before beginning, thoroughly clean the
headlight lens surfaces to make sure they
are free of any dirt or contaminants.
Be sure to use the Alchohol Prep Pads and
3M Adhesion Promoter Pads as instructed.
Contents:
(2) - Headlight Splitters (Left & Right)
(1) - Tape Kit
(2) - 3M Adhesion Promoter Pads
(2) - Alcohol Prep Pads
Step 1
Using the supplied alcohol prep pads,
thoroughly wipe down the back of the
head light splitter and the center of the
headlight lens where the splitter will
attach. Once the alcohol has dried, repeat above steps using the included 3M Adhesion Promoter Pads.
Step 2
Starting from the rear transition edge of
the splitter, install the provided 3M tape as shown.
Step 3
Remove the backing from the 3M tape and install the splitter onto the headlight.
Start by aligning the outside edge in the
center of the small reflector as shown.
Step 4
Rotate the splitter down until it meets the grille surround of the bumper cover.
Repeat steps 1-4 for the opposite side.
