Guaranteed 12/24 Delivery Still Available see item page for details! available on most items - Details
Best Sellers
How to Install MMD Tail Light Trim on you 2013 Mustang
Shop Parts in this Guide
Before beginning, thoroughly clean the tail
light lens to make sure they are free of any
dirt or contaminants.
Step 1
Use the supplied alcohol pads to
thoroughly wipe down the areas where the adhesive tape from the tail light trim will contact the light.
Step 2
Peel the backing from the 3M tape as
shown above.
Step 3
Beginning with the outside edge, carefully place the trim over the tail light, making sure to align the edges of the trim with the edges of the LED surrounds on the light. Do not press down at this point to fully
seat the adhesive.
Step 4
Once the trim is properly located, firmly
press down to fully seat the adhesive tape.
Step 5
Repeat Steps 1-4 for opposite side
trim to complete the installation.
