How to install SHR GT Lower Grille Inserts on your 2005-2009 Mustang

Thank you for your purchase of SilverHorse Racing products. Please read all directions before beginning the installation. A factory shop manual should be available for reference during installation. If, after reading these and any accompanying directions, you feel that you may not be able to complete the installation safely and properly, please seek out professional installation by certified technicians. Please read and understand our product purchase agreement (included on yellow sheet) prior to starting installation. Vehicle should be off with key removed from ignition and in park with parking brake set prior to beginning installation.

1. Start with a clean car for best results. Remove any wax/sealants on the area where the inserts will be installed. The inserts are labeled Driver / Passenger on the back side of the pieces to aid in simplifying installation.

2. Install the pieces from the front of the vehicle with the text up and to the backside (they will only fit correctly one way) until they snap into the existing lower grill. Slightly pull forward on the insert to insure that the retaining clips are securely engaged to the back of the existing lower grill.

3. If desired for permanent added protection of cooling components, glue / cement compatible with ABS plastics may be used or the parts drilled / and riveted to the existing lower grill insert. Removal of the lower grill is recommended to reduce the risk of damage to bumper cover.

4. If parts need to be removed for cleaning / maintenance and they have not been glued or riveted in place, they can be removed by pushing on the outer lower corner or the piece until it pushes through the grill – take care not to push into any coolers behind the grill, then rotate to the horizontal position and retract piece from the lower grill.