Mustang Lower Billet Grille ('94-'98) - Installation Instructions

1. If the car's setup prevents you from accessing the rear of the lower grille, use your preferred method for raising the front of your car to gain access.

2. An additional set of hands will be very useful for this installation. Center the grille insert in the bumper opening. Note that you may need to bend the billet bars slightly to align with your particular car’s fit.

3. From the back of the grille, slide the two provided clips over the back of the upper lip of the lower grille opening. Space them about 1/3 of the way between the edge of the opening and the center bar.

4. Center your grille. Have your assistant hold the grille in place. From the back of the grille, thread the two provided wires through the clips and then back through the front of the grille, wrapping them around the side bars of the grille.

5. Twist the wires until the grille is held securely in place. Trim excess wire with wire cutters and wrap the ends of the wires in electrical tape to prevent scratching your paint.

6. Check to make sure your grille is centered.

7. Congratulations, you're finished. Enjoy your new billet grille from Stack Racing.

Installation instructions provided by Stack Racing